Filter
Top Products
44
THE PERFECT FIT
FAST M-10 Rear Suspension Adjustments
Static Sag and Ride Height Settings
FRA Position
The F RA setting is the primary rear suspension adjustment. It will have
the MOST effect on the rear suspension performance. To adjust the
FRA:
1. Refer to t he initial set-up reference chart (located under the hood of
your snowmobile and on page 49) to determine the desired FRA
position.
2. To adjust, loosen the hex bolts (A) attaching the rear lower shock
cross shaft to the rail beam.
3. Using a 9/16” wrench, loosen the jam nuts (B) on the preload
bolts.
4. Adjust the preload bolts (C) t o the desired FRA position.
5. Tighten the jam nuts.
NOTE: Make sure the preload bolt contacts the slide block before
tightening the jam nut.
6. Ti ghten the hex bolts and torque to 35 ft. lbs. (47 Nm).
NOTE: If the M-10 suspension is new, it will take from 25 to 200
miles to properly break in the springs and shocks, at which
time the suspension will be softer and may require FRA
readjustment.
A
B
C