Filter
Top Products
78
ADULT SECTION
Maintenance
Ski Skags
The skag (A) is a replaceable bar
attached to the underside of
the ski. The purpose of the
skag is to assist in turning
the snowmobile and to
prevent the wearing away of the
ski caused by contact with roads
and other bare terrain. We
recommend that skags be checked
once a week to maintain positive
steering characteristics. Skags must be replaced when worn to half
their original diameter.
NOTE: See dealer track studding and skag chart for recommended
skags.
WARNING
Worn skis and/or skags will adversely af fect handling and can
cause loss of vehicle control, which can lead to serious injury or
death. Replace worn skis and/or skags when inspection reveals
wear.
Skag Replacement
1. Raise and support the front of the machine so the skis are
approximately 6″ (15.2 cm) from the ground.
2. Remove the attaching nuts and pry the skag downward.
3. Remove the forward portion of t he skag.
Reverse this procedure for new skag installation.
NOTE: If the rear idler wheel
assembly (1) washers
are removed, be sure
they are reinstalled with
the domed side of the
washer facing out (2) as
shown.
A
2
1