Filter
Top Products
7. START RECORDING THE EXERCISE
1. Start by pressing OK. The training computer enters pre-training mode
and starts searching for the sensor signals.
If a sensor signal is not found, a triangle with an exclamation mark is
shown on the display. A check mark indicates that the sensor signal
is found.
2. Select the sport profile (Running, Cycling 1 (Bike 1), Cycling 2
(Bike 2 ) or Other sport) by browsing with UP/DOWN.
3. Once all the sensor signals are found, press OK. Recording
started is displayed, and you can start the training session.
• Change the training view by browsing with UP/DOWN.
• Access the QUICK MENU by pressing and holding LIGHT for two
seconds.
• For further information on the functions during training, see the full
user manual at www.polar.com/support.
16 ENGLISH