Filter
Top Products
Installing the Firmware Update into your AVIC-X930BT
Step 3
Load the microSD card into your AVIC-X930BT. The system will automatically reboot and start the update
process within one minute.
WARNING! While your navigation system is being updated, do NOT turn off the power to the
navigation system. Severe damage to your navigation system could result from your failure to obey
this warning, including but not limited to the loss of all content/data that is stored on the internal
Flash Memory (such as address book entries and other user information).
If your system does not reboot and start the update process within one minute, then please check your
system and microSD card as follows:
• Check the model number of your navigation system and check the version number of your current
software, as detailed above in the “Before Updating” section.
• Check the microSD Card and confirm that the ‘AVICZ110’ folder is the only folder on the SD card.
There should be no other files.
Step 4
Please wait a few minutes (approximately 3 to 5 minutes) for the firmware update to be completed. The
AVIC-X930BT will automatically reboot after the firmware update is completed.
Step 5
Once the firmware update is completed, please perform the following steps to confirm that the firmware
update was successful:
• Press the “HOME” key
• Select the “Settings” tab
• Select “System Settings”
• Select “Service Information”
• Press & hold left upper corner of the “Service Information” screen for a few seconds
• Confirm that your system correctly displays the below information:
Platform Version: 3.000
Application Version: 3.001
Step 6
Please eject the microSD Card from the AVIC-X930BT. Your AVIC-X930BT is now ready for use.
Questions
If you have any questions, please contact Pioneer Customer Service toll free at 800-421-1404, Monday
through Friday from 10:00 a.m. to 7:30 p.m. (Eastern Time), except holidays.
------------------------------------------------------------
Copyright 2011 Pioneer Corporation