Filter
Top Products
6
Testing the PESWIPS
Note: For Sony head units, please refer to the note below.
Test each Heater function of the steering wheel controls. The
TEMP and FAN should work properly. When testing the audio
controls, the left LED on the PESWIPS will fl ash indicating it
is sending a command. If any function does not work, repeat
the pro gram ming in struc tions (starting from Step 11) or refer to
Troubleshooting Guide.
VOL
TEMP
Sony Head Units only!: If the Volume and Track/
Seek settings are reversed, you need to program the head
unit to reverse the input. Please refer to the radio's Owners
Manual to change this feature for the wired remote.
3
11-29-05
PESWIPS
PESWIPS
Programming the PESWIPS to Work With the Vehicle
Step 6.
Press and hold programming/
mode button on PESWIPS. Turn
the vehicle ignition to the ON
position.
The LED on the
PESWIPS will light.
Step 7.
Release the programming/
mode button.
The LED will turn off,
indicating memory is
cleared.
Step 8.
Press and release the program-
ming/mode button the same
number of times as the desired
version number.
The LED will fl ash
each time the button is
pressed and released.
Step 9.
After 3 seconds, the
LED will fl ash the same
amount of times of set
version number.
Step 10.
Turn vehicle ignition
to OFF position.
Vehicle programming
sequence is complete.
PESWIPS
OFF
ACC
IGN
STRT
OFF
ACC
IGN
STRT
PESWI
PS
PESWI
PS
PESWIPS
Step 5.
Refer to The Vehicle Appication Guide. Note the INTERFACE Version Number next to the selected vehicle. Fill in the information
below for quick reference.
Version Number: ____________
(Write Version Number here)
PESWIPS