Filter
Top Products
5
07-23-09
SWI-PS
SWI-PS
Programming the SWI-PS to Control the Head Unit (cont.)
Step 22.
Release the button.
The LED will turn on
back on. Skip to Step
24.
Step 24.
If you need to program more buttons,
repeat step 20 for each additional audio
function on the steering wheel.
Once programming
is completed, wait 7
seconds. The LED will
ash three times indi-
cating end of program-
ming. The Interface will
then ash the version
number it was pro-
grammed for.
Step 21.
Within 7 seconds, press and
hold the button that is to be
learned on the steering wheel.
The LED will turn off
when the button has
been learned.
SWI-PS
After all buttons are
programmed
Program
remaining buttons
VOL
VOL
1. Volume Up
2. Volume Down
3. Mute
4. Track Up/Seek Up
5. Track Down/Seek Down
6. Source
7. Preset Up/Disc Up
8. Preset Down/Disc Down
9. Band
10. Phone Status
11. Answer Call
12. End Call
The SWI-PS must be programmed in the specic order shown below. If a function is not needed, it may be skipped.
SWI-PS
Step 23.
Within 7 seconds,
press and release the
programming/mode
button on the SWI-PS.
SWI-PS
The LED will ash
once and stay on.
This will indicate
that the function
has been skipped.
Skip to Step 20.
Step 20.
A. If the current function above is what you
need to program, proceed to step 21.
B. If the current function above is not needed,
proceed to step 23
Example: If you have a vehicle with only 3 functions, and you want to program Volume Up, Volume Down and Source. You will do
Step 21-22 twice, the rst time for Volume Up, the second time for Volume Down. Step 23 will be done 3 times to skip
Mute, Track Up and Track Down. Do Step 21-22 to program Source. After all 3 buttons have been programmed, you will
proceed to Step 24.