Nissan 2007 350Z Automobile User Manual


 
CRUISE CONTROL (if so equipped)
To activate the cruise control, push the ON
.
OFF switch.
The indicator light in the instrument panel will illuminate.
To set cruising speed, accelerate the vehicle to the
desired speed, push the COAST/SET switch and
release it. The SET indicator light in the instrument panel
will illuminate.
To reset at a faster cruising speed, push and hold the
ACCEL/RES switch. When the vehicle reaches the speed you desire, release the switch.
To reset at a slower cruising speed, push and hold the COAST/SET switch. Release
the switch when the vehicle slows to the desired speed.
To resume a preset speed, push and release the ACCEL/RES switch. The vehicle
returns to the last set cruising speed when the vehicle speed is over 25 MPH (40 km/h).
To cancel cruise control, push the CANCEL switch or tap the brake pedal. The SET
indicator light in the instrument panel will go out.
To turn off cruise control, push the ON
.
OFF switch. Both the CRUISE indicator light
and the SET indicator light in the instrument panel will go out.
STEERING WHEEL SWITCHES FOR AUDIO
CONTROL (if so equipped)
With the ignition switch turned to the ACC or ON
position, push the PWR (Power) on/off switch to turn
the audio system on or off.
Push the MODE select switch to change the mode.
Without satellite radio: AM, FM1, FM2, and
CD or CD changer.
With satellite radio: AM, FM1, FM2, SAT1, SAT2 and CD changer.
The SEEK switch can be used to perform the following:
Radio memory change – Push the
< >
switch for less than 1.5 seconds to
change the radio frequency.
Radio tuning – Push and hold the
< >
switch for more than 1.5 seconds to
seek the next or previous radio station.
CD track change – Push the
< >
switch for less than 1.5 seconds to return to the
beginning of a CD track or skip to the next track.
CD disc change – Push and hold the
< >
switch for more than 1.5 seconds to
change the playing disc.
MP3 folder change – Push and hold the
< >
switch up or down for more than 1.5
seconds to change the folders (if folders exist).