Filter
Top Products
1-10
W300
NAVMAN
3.3.1 Enter setup
To enter setup
Press and hold
to turn the power on and enter setup.
When the counter reaches zero, the W300 will enter setup. If
you release
before the counter reaches zero the W300 will
immediately start normal operation.
Note: To enter setup after starting normal operation you will need to
restart the W300. For details about changing settings see Section
4.0.
To leave setup
Press and hold
to leave setup and start normal operation.
When the counter reaches zero, the W300 will leave setup and
start normal operation in Speed mode. If you release before
the counter reaches zero the W300 will remain in setup.
Note: you must leave setup first if you want to turn the power off.
3.3.2 Start normal operation
To start normal operation
Press
to turn the power on and start normal operation.
When starting directly into normal operation, the W300 will start
in the mode it was in at last shutdown. (Speed mode is always
displayed first when starting normal operation after leaving
setup.) For details about normal operating modes see Section
5.0.
W300 – Getting started
counter
counter