Filter
Top Products
00-02-0605 - 21 - Rev 09-10-08
Auxiliary Gage Fault
Murphy’s PVA Gages can be attached to the PowerView. If
an auxiliary gage should fail, the 1-up or 4-up display will be
replaced with the fault message “GAGE NOT
RESPONDING”.
NOTE: The fault can only be cleared by correcting the
cause of the fault condition.
Active Fault Codes
When the PowerView receives a fault code from an engine,
the 1-up or 4-up display will be replaced with the active fault
codes message.
Derate / Shutdown Codes
When the PowerView receives a severe fault code from an
engine control unit the 1-up or 4-up display will be replaced
with the SHUTDOWN message.