Filter
Top Products
PAGE 18 — QP3TY TRASH PUMP — OPERATION AND PARTS MANUAL — REV. #2 (11/15/10)
QP3TY — INITIAL START-UP (ENGINE)
DO NOT attempt to operate the pump
until the Safety, General Information and
Inspection sections of this manual have
been
read and thoroughly
understood
.
This section is intended to assist the operator with the
initial
start-up
of the trash pump. It is extremely important that this
section be read carefully before attempting to use the pump in
the field.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Figure 7. Open Fuel Cock
Starting the Engine (
YANMAR
engine)
2. Open the fuel cock (Figure 7).
3. Move the engine speed lever to the START position
(Figure 8).
Figure 10. Decompression Lever
5. Push down decompression lever (Figure 10) and
release.
6. Pull the starter grip again, hard and fast, pulling it all the
way out to start engine.
7. If the engine does not start, repeat steps 4 to 6.
Figure 9. Starter Grip
Do not allow the starter grip to snap back against the engine.
Return it gently to prevent damage to the starter.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Figure 8. Engine Speed Lever (START position)
CAUTICAUTI
CAUTICAUTI
CAUTION
ALWAYS run engine at
full speed
while pumping.
4. Grasp the starter grip (Figure 9) and slowly pull it out until
you feel the strongest resistance then return the starter grip
to the initial position.
START
ENGINE SPEED
LEVER