Filter
Top Products
PAGE 14 — MTX80/90 RAMMER — OPERATION AND PARTS MANUAL — REV. #9 (1/14/11)
Rammer Crankcase and Spring Cylinder Oil Bath
This unit uses an oil bath lubrication system. Perform the following:
1. Check the oil level through the oil level sight glass (Figure 3)
at the rear of the tamper foot.
This section is intended to assist the operator with the initial
start-up of the MTX80/MTX90 Tamping Rammer. It extremely
important that this section be read carefully before attempting
to operate the rammer.
DO NOT use your rammer until this section is thoroughly
understood.
2. Check the engine oil level and if the engine oil level is low,
it should be refilled. Low levels of oil may result in engine
seizure. Use the proper motor oil as suggested in the Table
3 below.
Figure 5. Engine Oil Dipstick
Figure 3. Foot Housing Sight Glass
2. If oil is not visible, add 10W-30 SE, SF or higher grade motor
oil into the oil fill plug opening (Figure 3). The bath contains
approximately 1.7 pints (800 cc.)
Figure 4. Fuel Tank
Engine
1. Fill the fuel tank (Figure 4) with unleaded gasoline. At the
same time, check the engine oil and make it a habit to
replenish it often (Figure 5).
edarGliOrotoM3elbaT
erutarepmeTronosaeS
liorotomfoedarG
)ssalcSMnahtrehgih(
nmutuAroremmuS,gnirpS
F°51+otF°021+
03EAS
retniW
F°5
1+otF°04+
03EAS
F°51+woleB03-W01EAS
SIGHT GLASS
OIL DRAIN PLUG
OIL FILL PLUG
FUEL
TANK
OIL LEVEL
DIPSTICK
OPERATION
Failure to understand the operation of the MTX80/MTX90
Tamping Rammer could result in severe damage to the
unit or personal injury.
CAUTION
The oil level should be kept at the half way point of the sight
glass.
NOTICE