Filter
Top Products
MANUAL TRANSMISSION (E-W) -
Control Lever
22A-7-2
PWEE9508
E
May 1995Mitsubishi Motors Corporation
DISASSEMBLY SERVICE POINTS
A
A
"
GEAR SHIFT MECHANISM REMOVAL
(1) Remove the compression spring 2 on the outside.
(2) Remove the snap ring 3 and take out the bearing bushes.
(3) Remove the two spring pins with spring pin extractor
MD998019.
(4) Remove the remote control arm 4.
(5) Withdraw the shift rail assembly together with the selector
dog 5.
(6) Remove the rubber seal.
(7) Remove the bearing bushes 6 from the shift lever 7.
(8) Remove the rubber seal 8 from the shift lever.
A
B
"
BEARING BUSHES REMOVAL
Tap out the two bearing bushes with 14 mm Hex socket.
REASSEMBLY SERVICE POINTS
"
A
A
BEARING BUSHES INSTALLATION
(1) Coat the mating faces of the housing with the specified
sealant.
(2) Locate the inner bearing bush and installer MB996007.
(3) Fit the remote control arm in the housing and insert a
7.5 mm diam. punch in the spring pin hole.
(4) Tap in the bearing bush until it abuts against its seating.
(5) Remove the punch, remote control arm and drift
MB996007.
(6) Locate the outer bearing bush and installer MB996007.
(7) Fit the remote control arm in the housing.
(8) Tap in the bearing bush until it abuts against its seating.
(9) Remove the remote control arm and installer MB996007.
MD998019
8
76
342
5
MB996007
MB996007