Filter
Top Products
ENGINE <4G6> -
Camshaft and Camshaft Oil Seal
11A-17
REMOVAL SERVICE POINTS
A
A
"
CAMSHAFT SPROCKET REMOVAL
A
B
"
ROCKER ARM AND SHAFT ASSEMBLY
REMOVAL
Before removing the rocker arm and shaft assembly, install
the special tools as shown in the illustration so that the lash
adjusters will not fall out.
INSTALLATION SERVICE POINTS
"
A
A
ROCKER ARM AND SHAFT ASSEMBLY
INSTALLATION
1. Temporarily tighten the rocker shaft with the bolt so that
all rocker arms on the inlet valve side do not push the
valves.
2. Fit the rocker shaft spring from the above and position
it so that it is right angles to the plug guide.
NOTE
Install the rocker shaft spring before installing the rocker
arm and rocker arm shaft on the exhaust side.
3. Remove the special tool for fixing the lash adjuster.
4. Confirm that the rocker shaft notch is in the direction
shown in the diagram.
MB990767
MD998719 or
MD998754
MD998443