Filter
Top Products
D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 56 of 90
7. Adjust remote control shift cable as follows:
a. Temporarily install shift cable end guide into shift lever, and insert anchor pin.
b. Adjust shift cable barrel so that hole in barrel centers with vertical centerline of stud.
Ensure that backlash center mark is aligned with edge of control cable end guide.
CAUTION
DO NOT attempt to install or remove remote control shift cable barrel from stud,
without first removing end guide anchor pin from shift lever, and removing cable.
Attempting to bend shift cable to install or remove barrel, will place undue stress
on cable end guide and shift lever, and damage to both could occur.
c. Remove shift cable end guide from shift lever, by removing anchor pin.
23242
a
b
c
e
d
a-Control Cable End Guide
b-Anchor Pin
c-Backlash Center
d-Control Cable Barrel
e-Stud
8. Install remote control shift cable.
23242
a
b
c
d
a-Lock Nut - Tighten Until Bottomed Out
b-Washers - Both Sides of Barrel
c-Anchor Pin
d-Cotter Pin (Not Visible) - Spread Both Ends
9. Remove adjustment tool.