Filter
Top Products
D7.3L D-TRONIC DIESEL ENGINES - BRAVO MODELS
Page 18 of 90
Hot Water Heater Installation Recommendation
IMPORTANT: When connecting a cabin heater or hot water heater, certain require-
ments must be met, including, but not limited to the following:
• Supply hose (from engine to heater) and return hose (from heater to engine)
MUST NOT EXCEED 5/8 in. (16 mm) I.D. (inside diameter).
• Make heater connections ONLY at locations indicated in the following informa-
tion.
• Refer to manufacturers’ instructions for complete installation information and
procedures.
IMPORTANT: Do not reposition engine temperature switch, it must remain where in-
stalled by factory.
CAUTION
Heater must be mounted lower than the fill cap on the heat exchanger. If the heater
is higher than the fill cap on the heat exchanger and some coolant is lost from sys-
tem, an air pocket may form in the closed cooling system. This can cause the engine
to overheat.
A Hot Water Heater Adaptor Kit is available from Quicksilver. This kit contains installation
instructions. Locations for fittings are shown following.
PART NUMBER
DESCRIPTION
854570A1 Hot Water Heater Adaptor Kit
SUPPLY HOSE CONNECTION
76024
71898
a
a-Location for Water Heater Supply Hose (Bayonet Fitting Replaces Plug)