Mercedes-Benz S 500 Automobile User Manual


 
98
Wheels
1 Wheel bolt for
7
1
/
2
J x 16 H 2 wheel rim
2 Wheel bolt for
8 J x 16 H 2 wheel rim
Replace rims or tires with the same
designation, manufacturer and type as
shown on the original part. See your
authorized Mercedes-Benz dealer for
further information.
Important!
The spare wheel rim size is
7
1
/
2
J x 16 H 2.
In the case of a flat tire or breakdown,
you may temporarily use a 7
1
/
2
J x 16
H 2 instead of the 8 J x 16 H 2 wheel
rim on the rear axle, when observing
the following restrictions:
Use only the wheel bolts
supplied in the vehicle tool kit.
Do not exceed vehicle speed of
50 mph (80 km/h).
Drive to the nearest repair
facility.
For additional information, refer to
"Technical Data".
Warning!
Do not mix different tire con-
struction types (i.e. radial, bias, and
bias-belted) on your car because
handling may be adversely affected
and may result in loss of control.
See your authorized Mercedes-Benz
dealer for information on tested and
recommended rims and tires for
summer and winter operation. They
can also offer advice concerning tire
service and purchase.
Tire Replacement
Front tires should be replaced in sets.
Furthermore - in the event of tire
replacement - the spare wheel, if
possible, should be used on the rear
axle. Rims and tires must be of the
same size and type. For dimensions,
see "Technical Data".
We recommend that you break in new
tires for approx. 60 miles (100 km) at
moderate speed. It is imperative that
the wheel mounting bolts be
retightened after approx. 60-300 miles
(100-500 km).