Filter
Top Products
i
If depressing the brake pedal the first
time does not activate the HOLD function,
wait briefly and then try again.
G
Warning
The vehicle's brakes are applied when the
HOLD function is activated. For this reason,
deactivate the HOLD function if the vehicle is
to be set in motion by other means (e.g. in a
car wash or by towing).
Deactivating the HOLD function
The HOLD function is deactivated
automatically if:
R
you accelerate and the transmission is in
position D or R.
R
the transmission is in position P.
R
you apply the brakes again with a certain
amount of pressure until HOLD disappears
from the multifunction display.
R
you activate DISTRONIC PLUS.
G
Warning
Never get out of the vehicle when the HOLD
function is activated.
The HOLD function must never be operated
or deactivated by a passenger or from outside
the vehicle.
The HOLD function does not replace the
parking brake and must not be used for
parking.
The braking effect of the HOLD function is
canceled and the vehicle could roll away if:
R
the HOLD function is deactivated by
depressing the accelerator pedal or the
brake pedal.
R
there is a malfunction in the system or an
interruption in the power supply, e.g.
battery failure.
R
the electrical system in the engine
compartment, the battery or the fuses are
tampered with.
R
the battery is disconnected.
If you leave the vehicle or park it, deactivate
the HOLD function and secure the vehicle
against rolling away.
You will see a warning message in the
multifunction display if the HOLD function is
activated and:
R
the driver's door is open and the driver's
seat belt is unfastened.
R
the engine is switched off.
R
the hood is opened.
Shift to 'P'
X
Move the selector lever to P to prevent the
vehicle from rolling away.
The HOLD function is deactivated. The
warning message in the multifunction
display disappears.
A horn will also sound at regular intervals if
the HOLD function is activated and you:
R
switch the engine off, open the driver's
door and take off your seat belt
R
open the hood
The sounding of the horn alerts you to the fact
that the vehicle has been parked while the
HOLD function is still activated. The tone
becomes louder if you attempt to lock the
vehicle. The vehicle is not locked until the
HOLD function is deactivated.
i
If the engine has been switched off, it
cannot be started again until the HOLD
function has been deactivated.
If there is a malfunction in the system or
power supply while the HOLD function is
activated, the Brake Immediately message
is shown in the multifunction display.
Immediately depress the brake firmly until
the warning message in the multifunction
display goes out.
You can also shift the transmission to position
P. This deactivates the HOLD function.
Driving systems
185
Driving and parking
BA 207 USA, CA Edition B 2011; 1; 3, en-US
d2sboike Version: 3.0.3.6
2010-05-20T10:38:09+02:00 - Seite 185
Z