Filter
Top Products
Replacing bulbs
358
Front turn signal lamp bulb
1
Mark
2
Handle
3
Bulb socket
X
Turn bulb socket 3 with handle 2
counterclockwise and remove it.
X
Pull bulb out of bulb socket 3.
X
Gently press the new bulb into bulb socket
3 until the bulb engages.
X
Place bulb socket 3 back into the housing.
Handle 2 must be in a horizontal line and
mark 1 must be on the upper part (driver’s
side headlamp) or lower part (passenger-
side headlamp).
X
Turn bulb socket 3 clockwise until it
engages.
Replacing bulbs for rear lamps
Before you start to replace a bulb for a rear
lamp, do the following:
X
Switch off the ignition.
X
Turn the exterior lamp switch to position
M.
X
Open the trunk.
Tail lamp unit
X
Driver’s side: Lift up the bottom and pull out
the trim panel covering the driver side rear
light.
X
Passenger side: Open the fuse box in the
trunk (Y page 373).
1
Tabs
2
Connector
X
Disconnect electrical connector 2.
X
Pull tabs 1 in direction of arrows.
X
Remove the bulb carrier.
Practical hints