Filter
Top Products
Control system
148
X
Press button % or $ to change the
setting which is highlighted.
X
Press # to store the entry.
Setting the date
This function is not available if your vehicle is
equipped with the COMAND system and
navigation module.
Vehicles with COMAND system:
For information on setting the date in the
COMAND system, refer to the separate
COMAND system operating instructions.
X
Press % or $ to select the Time/
date submenu.
X
Press #.
X
Press % or $ to select the Date
function.
X
Press #.
The current date appears in the
multifunction display.
X
To set a new date press # again.
X
Press button ( or & to select the
setting you wish to change: month, day or
year.
X
Press button % or $ to change the
setting which is highlighted.
X
Press # to store the entry.
Lights submenu
Access the Lights submenu via the
Settings menu. Use the Lights submenu to
change the lamp and lighting settings on your
vehicle.
The following functions are available:
R
Setting daytime running lamp mode (USA
only) (Y page 148)
R
Setting locator lighting and night security
illumination (Headlamps delayed shut-off
feature) (Y page 149)
R
Setting interior lighting delayed shut-off
(Y page 150)
Setting daytime running lamp mode (USA
only)
X
Press % or $ to select the Lights
submenu.
X
Press #.
X
Press % or $ to select the Daytime
Running Lamps: function.
The current setting Enabled or Disabled
is shown.
X
Press # to change the current status.
Depending on the previous status, the
daytime running lamps feature will be
Enabled or Disabled.
With Daytime Running Lamps mode
Enabled selected and the exterior lamp
switch at position M or *, the low-
beam headlamps are switched on when the
engine is running.
Controls in detail