Filter
Top Products
62
Getting started
Parking and locking
Locking with the SmartKey
̈ After exiting the vehicle, press lock
button ‹ on the SmartKey
(
୴ page 36).
With the trunk and all doors closed:
ț All turn signal lamps flash three
times.
ț An acoustic signal sounds three
times.
For more information, see “Factory
setting” (
୴ page 106).
ț The locking knobs in the doors
move down.
ț The anti-theft alarm system is
armed.
For more information, see “Locking and
unlocking” (
୴ page 100).
Locking with KEYLESS-GO*
1 Lock button
̈ After exiting the vehicle, press lock
button 1 at the outside door handle or
on the trunk lid.
With the trunk and all doors closed:
ț All turn signal lamps flash three
times.
ț An acoustic signal sounds three
times.
For more information, see “Factory
setting” (
୴ page 106).
ț The locking knobs in the doors
move down.
ț The anti-theft alarm system is
armed.
For more information, see “Locking and
unlocking” (
୴ page 100).
i
If you hear a warning signal you have forgot-
ten to switch off the low beam headlamps or the
parking lamps before opening the driver’s door.
In addition the message
Switch Off Lights
appears in the multifunction display.
Switch off the low beam headlamps or the park-
ing lamps.
If the message
Switch Off Lights or
Remove Key
appears in the multifunction dis-
play remove the SmartKey from the starter
switch or switch off the automatic headlamp
mode.
!
Failure to switch off the exterior lamps when
leaving the vehicle may result in a discharged
battery.