Filter
Top Products
56
Getting started
Driving
Windshield wipers
The combination switch is located on the
left of the steering column.
Combination switch
1 Single wipe
Wiping with washer fluid
2 Switching on windshield wipers
̈ Switch on the ignition (୴ page 38).
Switching on windshield wipers
̈ Turn the combination switch to the de-
sired position depending on the inten-
sity of the rain.
M Windshield wipers off
U Slow intermittent wiping
Rain sensor operation with low
sensitivity.
V Fast intermittent wiping
Rain sensor operation with high
sensitivity.
u Slow continuous wiping
t Fast continuous wiping
i
To signal minor directional changes such as
changing lanes, press combination switch only
to point of resistance and release. The corre-
sponding turn signals will flash three times.
!
Do not operate the wipers when the wind-
shield is dry. Dust that accumulates on a wind-
shield might scratch the glass and/or damage
the wiper blades when wiping occurs on a dry
windshield. If it is necessary to operate the wip-
ers in dry weather conditions, always operate
the wipers with washer fluid (
୴ page 57).
!
If anything blocks the windshield wipers
(leaves, snow, etc.), switch them off immediate-
ly.
ț For safety reasons, stop the vehicle in a safe
location
ț turn off the engine by turning the
SmartKey to position 0 and withdraw
SmartKey from starter switch
or
ț turn off the engine by pressing the
KEYLESS-GO* start/stop button and
open the driver’s door (with the driver’s
door open, starter switch is in
position 0, same as with SmartKey re-
moved from starter switch)
before attempting to remove any blockage.
ț Remove blockage.
ț Turn the windshield wipers on again.
!
If windshield wipers fail to function at all in
combination switch position U or V,
ț set the combination switch to the next high-
est wiper speed
ț have the windshield wipers checked at the
nearest authorized Mercedes-Benz Center
୴୴