![](http://pdfasset.owneriq.net/d/97/d9747648-c280-470f-88ae-a6dbb0919a6a/d9747648-c280-470f-88ae-a6dbb0919a6a-bg37.png)
53
Getting started
Driving
Intermittent wiping
̈ Turn the combination switch to
position I.
Single wipe
̈ Press combination switch briefly in the
direction of arrow 1.
The windshield wipers wipe one time
without washer fluid.
Wiping with windshield washer fluid
̈ Push combination switch in the direc-
tion of arrow 1 past the resistance
point.
The windshield wipers operate with
washer fluid.
For information on filling up the washer
reservoir, see “Windshield washer system
and headlamp cleaning system*”
(
୴ page 315).
i
The intermittent wiping is interrupted
when the vehicle is at a standstill and a
door is opened.
!
If anything blocks the windshield wip-
ers (leaves, snow, etc.), switch them off
immediately.
ț For safety reasons,
ț turn off the engine by turning
the SmartKey to position 0 and
withdraw SmartKey from starter
switch
or
ț turn off the engine by pressing
the KEYLESS-GO* start/stop
button and open the driver’s
door (with the driver’s door
open, starter switch is in posi-
tion 0, same as with SmartKey
removed from starter switch)
before attempting to remove any
blockage.
ț Remove blockage.
ț Turn the windshield wipers on
again.
If windshield wipers fail to function at
all in switch position I,
ț set the combination switch to the
next highest wiper speed
ț have the windshield wipers
checked at the nearest authorized
Mercedes-Benz Center