Filter
Top Products
183Interior equipment
Technical
data
Instruments
and controls
Operation Driving
Instrument
cluster display
Practical hints Car care Index
1 Lock and unlocking handle
2 Quick Lock
3 Lock
4 End stop joint
To lower brush guard:
While holding brush guard firmly, open quick lock (2)
using lock and unlocking handle (1). Gently lower brush
guard until it reaches its fully lowered position.
To raise and secure brush guard:
Flip up brush guard until it contacts end stop joint (4).
The quick lock stop pin (2) must engage the cross slot
recess in the lock (3).
Now turn quick lock (2) so that quick lock is making
contact with end stop joint (4).
Lock quick lock (2) on both sides of brush guard using
lock and unlocking handle (1).
Important!
Make sure that both quick lock stop pins (2) are seated
fully in lock (3).
J_G463.book Seite 183 Mittwoch, 19. September 2001 8:06 08