Filter
Top Products
177Interior equipment
Technical
data
Instruments
and controls
Operation Driving
Instrument
cluster display
Practical hints Car care Index
Installation behind front seats:
To install, fold rear seat bench cushion fully forward.
1. Open storage compartment (2) below rear seat
bench.
2. Engage partition net in holders (1). The lift
tensioner (3) must point in the direction of the cargo
compartment.
3. Set the length of the tie downs (4) and lift
tensioner (3) to the rings (6).
4. Insert tie down hooks (5) in rings (6). Pull on loose
ends of tie downs until net is tight.
After driving a short period, check the tension of the
partition net, re-tighten if necessary.
1 1
J_G463.book Seite 177 Mittwoch, 19. September 2001 8:06 08