Filter
Top Products
Black plate (256,1)
1. For vehicles equipped with an engine
cover, remove the engine cover.
2. Remove the battery cover from its front
side.
3. Make sure the booster battery is 12 V
and that its negative terminal is
grounded.
4. If the booster battery is in another
vehicle, don't allow both vehicles to
touch. Turn off the engine of the
vehicle with the booster battery and all
unnecessary electrical loads in both
vehicles.
5. Connect the jumper cables in the exact
sequence as in the illustration.
l
Connect one end of a cable to the
positive terminal on the discharged
battery (1).
l
Attach the other end to the positive
terminal on the booster battery (2).
l
Connect one end of the other cable
to the negative terminal of the
booster battery (3).
l
Connect the other end to the ground
point indicated in the illustration
away from the discharged battery
(4).
6. Start the engine of the booster vehicle
and run it a few minutes. Then start the
engine of the other vehicle.
7. When finished, carefully disconnect the
cables in the reverse order described in
the illustration.
8. If the engine cover and the battery
cover have been removed, install them
as they were previously installed.
NOTE
Verify that the covers are securely installed.
7-18
In Caseof anEmergency
Emergency Starting
Mazda5_8Z98-EA-08F_Edition1 Page256
Friday, May 30 2008 9:26 AM
Form No.8Z98-EA-08F