Filter
Top Products
This unit can be programmed to start and run the engine every 2 or 3 hours. The engine will run
for the programmed run time and then shut down. This feature is designed for an extreme cold
climate. The system will automatically start the vehicle every 2 or 3 hours to prevent engine from
cold hard to start and freezing over. A MAXIMUM OF SIX CYCLES CAN OCCUR.
Important: Timer start should be used in open areas, never start and run the vehicle in enclosed
spaces as a garage or carport
To Activate the Start Timer:
1. Press the button twice to remote start the vehicle. As soon as the vehicle is running and
the parking lights have turned on or flashing.
2. Immediately depress the button then depress the button. The parking lights will flash
(3) times. The siren or horn chirps (3) times. The vehicle is now programmed to start
every 2 or 3 hours.
3. Press the brake pedal to stop the vehicle from running.
Note:
Unless the installer of this remote start system has reprogrammed the start timer for a 2 hour
duration, the default programmed start time is set to 3 hours.
Exit the Timer Start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition to the “On” position. The LED and parking lights will flash (4) times. The
horn or siren chirps (4) times.
or
1. Press the button twice to remote start the vehicle. As soon as the vehicle is running and
the parking lights have turned on or flashing.
2. Immediately depress the button then press and hold the button for 2 seconds. The
parking lights will flash (4) times. The siren or horn chirps (4) times. The vehicle is no
longer programmed to start automatically.
If any of the following conditions exist while the system is operating, the engine will not start or
will shut down:
1. The hood is open.
2. The brake pedal is pressed.
3. Move the optional remote start enable toggle switch to “Off” position (If installed).
4. Engine is over-revved (Tachometer Checking Type).
5. The pre-programmed run time 5-10-20-30 minutes has elapsed.
6. Transmitter button is pressed twice.
7. The vehicle refused to start running after 3 unsuccessful attempts.
This feature allows your security system’s remote start unit to be temporarily disabled to prevent
the vehicle from being remote started accidentally. This feature is useful if the vehicle is being
serviced or stored in an enclosed area. To disable the remote start, move the optional remote
start enable toggle switch to the “Off” position. (If installed)
8
Remote Start Operation (continued)
Timer Starting
Shut-Down Inputs for Remote Starter
Disabling the Remote Start System