5
Press and hold the ARM/DIS or PANIC or LOCK button for more than 3 seconds and the security system
will respond in the following manner:
A. The horn/siren will begin sounding.
B. The parking lights will begin flashing.
To turn off the panic alarm, press and release the ARM/DIS or PANIC button on the transmitter. The
horn/siren will stop sounding and the parking lights will stop flashing.
Note 1: If you do not turn off the panic feature with the transmitter, the panic alarm will sound for 60
seconds and then turn off by itself.
Your security system can be instructed to become armed or disarmed without the horn/siren chirps by the
remote transmitter. To operate this feature at any time, simply press the ARM/DIS button and the AUX button or
the LOCK and UNLOCK button at the same time to arm or disarm your security system without the chirp
indications.
If your security system has become triggered, the horn/siren will sound for 60 seconds and then stop and re-
set to a fully armed condition.
Note: If a protected entrance is left open, your security system will remain triggered for two more 60 second
cycles then fully re-arm excluding the door input trigger. (Door input trigger is no longer functional) Closing the
entrance will re-set the door input trigger within 7 seconds.
Every time you disarm the security system with your transmitter, the security system will start an RF protection
mode countdown. This is a timed secondary protection mode to insure that the radio signal used to disarm the
security system was from your transmitter. After the system is disarmed by radio signal, it will count down for
60 seconds and then become re-armed if no one enters the vehicle.
Note: The feature is only active when the security system has been programmed to automatically arm.
Remote Panic
User Discretion Silent Arming:
60 Second Re-Arming
Secondary RF Protection Mode