Note: The following information is valid only if your security system has been programmed to automatically
arm.
1. Turn off the ignition key and exit the vehicle.
2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one
time and the LED indicator will begin to flash fast. The fast flashing LED indicates that the automatic
arming timer is counting down and the security system will become armed within 30 seconds. After 30
seconds has passed, the security system will respond in the following manner:
A. The horn/siren will chirp one time.
B. The LED indicator will begin to flash slower.
C. The parking lights will flash one time.
D. All protected entrances are armed.
Note 1: Re-opening a protected entrance before the system becomes armed will stop the arming timer .
After closing the entrance the timer will begin counting again from zero.
Note 2: If the vehicle has a delayed interior lighting system, the automatic arming timer will start
counting after the interior lighting has turned itself off. This could add up to 45 seconds to the total
automatic arming countdown time. (Up to 75 seconds total arming delay)
The security system is now fully armed!
3
Press and release the ARM/DIS or UNLOCK button on the transmitter. The security system will respond as
follows:
A. The horn/siren will chirp two times.
B1.The LED indicator will be off. (Only if Auto Arming is programmed off)
B2.The LED indicator will be flashing very fast. (Only if Auto Arming is programmed on)
C. The parking lights will flash two times.
Note: If you are disarming the security system after it has been triggered and the horn/siren is sounding,
the disarm chirps are automatically deleted.
The security system is now disarmed!
Automatic Arming: (Without using the transmitter)
Disarming the Security System Using the Transmitter