Magnadyne 4900 Series Automobile Alarm User Manual


 
4
The Valet Mode allows you to temporarily turn off the passive arming function, eliminating the need
to give your transmitter to a parking attendant or garage mechanic.
To enter the Valet Mode, follow these steps:
1. Press the “Disarm” button on your transmitter to insure the device is disarmed (you will hear
2 beeps).
2. Within 3 seconds of pressing the disarm button, press and release the “Valet On” button 3
times slowly. The device will emit 3 long beeps to indicate the Valet Mode is “On”.
3. Within 30 seconds, start the vehicle’s engine and then shut it off to secure the Valet Mode. If
this step is not completed, the Silencer unit will become armed and your transmitters will not
function. If this happens, follow the Emergency Override procedure on page 5 to disarm your
system.
To exit the Valet Mode, follow these steps:
1. Press the “Disarm” button on your transmitter (you will not hear any beeps).
2. Within 3 seconds of pressing the disarm button, press and release the “Valet Off” button 3
times slowly. The device will emit 1 long beep to indicate the Valet Mode is “Off”.
Valet Mode
3-Button Transmitter
To enter the Valet Mode, follow these steps:
1. Press the button on your transmitter to insure the device is disarmed (you will hear 2 beeps).
2. Within 3 seconds of pressing the button, turn ignition On/Off 3 times and wait about 3 seconds,
the device will emit 3 long beeps to indicate the Valet Mode is “On”.
To exit the Valet Mode turn the ignition On/Off 3 times and wait about 3 seconds, the device will emit
1 long beep to indicate the valet mode is “Off”.
1-Button Transmitter (Includes Automatic Disarm Transmitter)
4900-UM.qxp 5/11/06 2:31 PM Page 4