Filter
Top Products
15
You will need to figure some way to prop the transducer into position
while you make your test run. A brick or two might be sufficient to hold
it in place.
5. When you are satisfied with a location, mark it and proceed with the
installation.
Shoot-thru-hull transducer locations for
high speed or trolling speed operation.
Shoot-thru-hull Installation
1. Make sure the area is clean, dry and free of oil or grease, then sand
both the inside surface of the hull and the face of the transducer with
100 grit sandpaper.
The sanded hull area should be about 1-1/2 times the diameter of the
transducer. The surface of the hull must be flat so the entire trans-
ducer face is in contact with the hull prior to bonding. After sanding,
clean the hull and transducer with rubbing alcohol to remove any
sanding debris.
Epoxy transducer to hull.
Transducer location
(trolling speed)
Transducer location
(high speed)
Spread epoxy here
Sand this surface
Orient the Skimmer
with the nose facing
the bow of the boat.
To bow