Filter
Top Products
Scenario 3:
Conditions - The automatic high beam system is set to ON in the
message center. The headlamp switch is in
(off), (park lamps),
or
(on).
Operation - The high beam switch can be used to turn the high beams
on and off.
Scenario 4:
Conditions - The automatic high beam system is set to OFF in the
message center. The headlamp switch is in
(auto
lamps),
(off), (park lamps), or (on).
Operation - The high beam switch can be used to turn the high beams
on and off.
Enabling/disabling auto high beams
Enabling/disabling and/or checking the status of the automatic high beam
system can be performed using the message center. See Message center
in the Driver controls chapter.
Activating high beams
If there is no traffic in front of the vehicle, the high beams will come on
automatically and the
light will display in the instrument panel if
the following are true:
• The headlamp control is in auto
lamp
mode.
• The ambient light level is low
enough that high beams are
needed.
• Vehicle speed must be greater
than 32 mph (51 km/h).
• Severe weather is not detected.
Deactivating high beams
The automatic high beams will deactivate if any of the following events
occur:
• An approaching vehicle’s headlights or a preceding vehicle’s tail lamps
are detected.
• The headlamp control is moved out of the autolamps position.
2009 MKS (mks)
Owners Guide (post-2002-fmt)
USA (fus)
Lights
43