Filter
Top Products
TROUBLESHOOTING »
TROUBLE CAUSE REMEDY
The battery is discharged The ignition (power consumer) has-
n’t been switched off
The battery isn’t charged by the
generator
Recharge the battery according to the relevant instructions.
Voltage regulator and generator should be checked by an
authorized KTM workshop.
No values are visible in the com-
bined instrument display.
Blown fuse Replace fuse 3
The speed indication on the
combined instrument is not
working
Pickup cable is damaged or con-
tacts on the cable connector have
oxidized
Check the pickup cable for damage, visit an authorized KTM
workshop
The blink code indicates which component is affected by an error. This allows the error to be identified if no diagnosis tool is available.
BLINK CODE SIGNAL / COMPONENT ERROR DESCRIPTION ENGINE
02 Pulse generator Malfunction Stalls
06 Throttle sensor Output signal too low /high Continues to run
07 Sensor for 2nd throttle valve Output signal too low /high Continues to run
09
Intake manifold air pressure for sensor rear cylinder
Output signal too low /high Continues to run
11
Intake manifold air pressure sensor for front cylinder
Output signal too low /high Continues to run
75