Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE »
80
Insert a new oil filter [1] in the engine case, grease the O-ring and mount the oil filter cover
together with the O-ring. Tighten the screws to 6 Nm.
Only use original KTM oil filters. The engine can be damaged if other filters are used.
Mount the oil drain plug on the oil tank with a new seal ring and tighten to 20 Nm.
Grease the seal ring [2] and carefully slide the oil screen into the oil tank. Position the oil
return valve [3], mount the screws and tighten to 10 Nm.
Mount the battery cover and tighten the screws to 25 Nm. Mount the lower screw on the
right tank and tighten to 25 Nm.
Attach the left tank to the upper bracket. Connect the fuel lines and connector for the fuel
pump and the pickup cable (fuel level). Fasten the tank with 3 screws and tighten the screws
to 25 Nm.
Open both fuel taps and the connecting line.
1
3
2