Filter
Top Products
RESETTING TRIP 2
The trip meter 2 runs continuously and counts up to 999.9. It can be used similarly to TRIP
1 or together with a switch available as an accessory (see below) for trips according to a
roadbook.
To return the trip meter 2 to zero, switch on the ignition, change to the TRIP 2 mode and
press the SET button.
NOTE:
A Tripmaster switch (Part no. 582.14.069.044) is available as an accessory and enhances
the trip meter 2 functions. You can correct the displayed route by increasing or decreasing
in increments of 0.1. For example, if you have taken the wrong road when driving accord-
ing to a roadbook, you can easily correct the display to correspond to the roadbook again. It
can also be used to change the display modes. The switch is mounted on the handlebars so
that you can keep your hands on the handlebars.
TRIP F
When the fuel level reaches the reserve mark, the display will automatically switch to TRIP
F and begin to count (no matter which display mode was active before). At the same time,
the fuel warning lamp will light up. You will still have enough reserve fuel for at least
30 kilometers.
After refueling, it will take approx. 8 minutes for the fuel warning lamp to switch off and for
TRIP F to automatically reset to 0 and return to the previous display mode.
NOTE:
Press the SET key for 2 seconds to immediately turn off the fuel warning lamp.
OPERATION INSTRUMENTS »
11
2