Filter
Top Products
ENGLISH
15
OPERATION INSTRUMENTS »
Compression damping of fork
Hydraulic compression damping determines the reaction when the fork is com-
pressed. The degree of compression can be adjusted with adjusting
screws at the bottom of the fork legs.Remove the protecting cap [1].
Turn the adjusting screws [2] clockwise to increase damping, turn it counter-
clockwise to reduce damping during compression.
STANDARD ADJUSTMENT
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
Typ White Power 14187A05...............22 clicks (SX)
Typ White Power 14187A06...............20 clicks (EXC/MXC)
Rebound damping of fork
Hydraulic rebound damping determines the reaction when the fork is
rebound. By turning the adjusting screw [3] (REB), the degree of damping of
the rebound can be adjusted. Turn the knob clockwise to increase damping,
turn it counterclockwise to reduce damping during rebounding.
STANDARD ADJUSTMENT
– turn adjusting screw clockwise as far as it will go
– turn it back by as many clicks as are specified for the relevant type of fork
Typ White Power 14187A05...............20 clicks (SX)
Typ White Power 14187A06...............20 clicks (EXC/MXC)
Damping action during compression of shock absorber (SX)
The shock absorber on the SX models can synchronize the compression
damping in the low and high-speed range separately (Dual Compression
Control).
Low and high speed refers to the movement of the shock absorber during com-
pression and not to the speed of the motorcycle.
The low and high-speed technology overlaps.
The low-speed setting is primarily for slow to normal shock absorber compres-
sion rates.
The high-speed setting is effective at fast compression rates.
Turning in a clockwise direction will increase the damping, turning
counterclockwise will decrease the damping.
STANDARD LOW-SPEED SETTING:
– turn the adjusting screw [4] to the limit in a clockwise direction using a
screwdriver .
– unscrew the respective number of clicks for the specific type of shock absor-
ber in a counterclockwise direction.
Typ White Power 12187A05...............15 clicks
STANDARD HIGH-SPEED SETTING:
– turn the adjusting screw [5] to the limit in a clockwise direction using a
box wrench.
– unscrew the respective number of turns for the specific type of shock absor-
ber in a counterclockwise direction.
Typ White Power 12187A05...............2 turns
THE DAMPING UNIT OF THE SHOCK ABSORBER IS FILLED WITH HIGH-COMPRES-
SION NITROGEN. NEVER TRY TO TAKE THE SHOCK ABSORBER APART OR TO DO
ANY MAINTENANCE WORK YOURSELF. SEVERE INJURIES COULD BE THE RESULT.
NEVER UNSCREW THE BLACK SCREW CONNECTION [6] (24MM).
1
2
2
3
3
5
6
4