KTM 250 EXC RACING Motorcycle User Manual


 
ENGLISH
10
OPERATION INSTRUMENTS »
LAP / LAP display mode (to view lap times)
The LAP/LAP display mode will only be shown if lap times have been stored
and the front wheel has stopped. It will display the lap number and the
stopped lap time in hours, minutes and seconds. Press the + button to access
the next lap time.
To clear all of the stored lap times, hold the | button for 3 seconds in the
SPEED/LAP mode.
+ button changes to the next lap time
button no function
briefly press | button changes to the next display mode
hold | button 3 secs. changes to the next display mode
SPEED / MAX display mode (maximum speed)
MAX displays the maximum speed traveled and is always active.
+ button no function
button no function
briefly press | button changes to the next display mode
hold | button 3 secs. clears the MAX figure
SPEED / TR1 display mode (tripmaster 1)
The TR1 tripmaster is always active and counts to 999.9. It is used to meas-
ure the length of a trip or the distance between 2 refueling stops.
TR1 is linked to A1 (average speed 1). The calculation of these figures is acti-
vated by the first impulse received from the wheel sensor (when the front wheel
starts to turn) and stops 3 seconds after the last impulse is received (when
the front wheel has stopped).
The TR1, A1 and S1 figures are automatically cleared after passing 999.9.
+ button no function
button no function
briefly press | button changes to the next display mode
hold | button 3 secs. clears the TR1, S1, A1 figures
SPEED / TR2 display mode (tripmaster 2)
The tripmaster 2 is always active and counts to 999.9. Contrary to TR1, the
displayed figure can be changed using the + and buttons. This is a very use-
ful function for trips taken according to a roadbook.
+ button increases the TR2 figure
button decreases the TR2 figure
briefly press | button changes to the next display mode
hold | button 3 secs. clears the TR2 figure
SPEED / A1 display mode (average speed 1)
A1 shows the average speed based on the TR1 (tripmaster 1) and S1 (stop
watch 1) figures. The calculation of this figure is activated by the first impulse
received from the wheel sensor and stops 3 seconds after the last impulse is
received.
+ button no function
button no function
briefly press | button changes to the next display mode
hold | button 3 secs. clears the TR1, S1, A1 figures