Filter
Top Products
5
General Recommendations
Purchase gasoline in small quantities and store in clean,
approved containers. A container with a capacity of 2
gallons or less with a pouring spout is recommended.
Such a container is easier to handle and helps eliminate
spillage during refueling.
Do not use gasoline le over from the previous season,
to minimize gum deposits in your fuel system and to
ensure easy starting.
Do not add oil to the gasoline.
Do not overfill the fuel tank. Leave room for the fuel to
expand.
Fuel Type
For best results use only clean, fresh, unleaded gasoline
with the pump sticker octane rating of 87 or higher. In
countries using the Research method, it should be 90
octane minimum.
Unleaded gasoline is recommended as it leaves
less combustion chamber deposits and reduces
harmful exhaust emissions. Leaded gasoline is not
recommended.
Gasoline/Alcohol blends
Gasohol (up to 10% ethyl alcohol, 90% unleaded
gasoline by volume) is approved as a fuel for Kohler
engines. Other gasoline/alcohol blends including E20
and E85 are not to be used and not approved. Any
failures resulting from use of these fuels will not be
warranted.
Gasoline/Ether blends
Methyl Tertiary Butyl Ether (MTBE) and unleaded
gasoline blends (up to a maximum of 15% MTBE by
volume) are approved as a fuel for Kohler engine.
Other gasoline/ether blends are not approved.
Engine Identification Numbers
When ordering parts, or in any communication
involving an engine, always give the Model,
Specification, and Serial Numbers of the engine.
The engine identification numbers appear on a decal
(or decals) affixed to the engine shrouding. Include
leer suffixes, if there are any.
Record your engine identification numbers on the
identification label (Figure 4) for future reference.
Refer to certification label for engine displacement.
Exhaust Emission Control System for models SV710-SV840 is
EM for U.S. EPA and Europe; PAIR for California Tier III.
EPA
CARB
Category C
250 hours
Moderate
125 hours
Category B
500 hours
Category A
1000 hours
Intermediate
250 hours
Extended
500 hours
Figure 4. Engine Identification Label.
The Emission Compliance Period referred to on the
Emission Control or Air Index label indicates the
number of operating hours for which the engine has
been shown to meet Federal and CARB emission
requirements. The following table provides the Engine
Compliance Period (in hours) associated with the
category descriptor found on the certification label.
Emission Compliance Period (Hours)
IMPORTANT ENGINE INFORMATION
THIS ENGINE MEETS U.S. EPA PH2 AND EC STAGE II
(SN:4) EMISSION REGS FOR SI SORE. NOT FOR SALE IN
CALIFORNIA UNLESS PREEMPT PER SEC. 209 (e) (1) OF CAA.
KOHLER CO. KOHLER, WISCONSIN USA
EMISSION COMPLIANCE PERIOD:
EPA: CARB:
CERTIFIED ON:
REFER TO OWNER'S MANUAL FOR HP RATING, SAFETY,
MAINTENANCE AND ADJUSTMENTS
FAMILY
TYPE APP
DISPL. (CC)
MODEL NO.
SPEC. NO.
SERIAL NO.
BUILD DATE
OEM PROD. NO.
1-800-544-2444 KohlerEngines.com
N11236
IMPORTANT ENGINE INFORMATION
THIS ENGINE MEETS U.S. EPA PH2 AND CA 2008 AND
LATER EXH EMISSION REGS FOR SI SORE. USING
DELEGATED ASSEMBLY FOR AFTERTREATMENT.
KOHLER CO. KOHLER, WISCONSIN USA
EMISSION COMPLIANCE PERIOD:
EPA: CARB:
CERTIFIED ON:
REFER TO OWNER'S MANUAL FOR HP RATING, SAFETY,
MAINTENANCE AND ADJUSTMENTS
FAMILY
TYPE APP
DISPL. (CC)
MODEL NO.
SPEC. NO.
SERIAL NO.
BUILD DATE
OEM PROD. NO.
N11236
1-800-544-2444 KohlerEngines.com