1.10
Section 1
Safety and General Information
Crankshaft (Cont'd.)
Connecting Rod Journal
O.D. - New ..................................................................................... 35.955/35.973 mm (1.4156/1.4163 in.)
O.D. - Max. Wear Limit .................................................................. 35.94 mm (1.415 in.)
Max. Taper ..................................................................................... 0.018 mm (0.0007 in.)
Max. Out-of-Round ........................................................................ 0.025 mm (0.0010 in.)
Crankshaft T.I.R.
PTO End, Crank in Engine ............................................................. 0.15 mm (0.0059 in.)
Entire Crank, in V-Blocks ............................................................... 0.10 mm (0.0039 in.)
Cylinder Bore
Cylinder Bore I.D.
New
LV560.......................................................................................... 73.006/73.031 mm (2.8742/2.8752 in.)
LV625.......................................................................................... 77.000/77.025 mm (3.0315/3.0325 in.)
LV675.......................................................................................... 80.000/80.025 mm (3.1496/3.1506 in.)
Max. Wear Limit
LV560.......................................................................................... 73.070 mm (2.8767 in.)
LV625.......................................................................................... 77.063 mm (3.0340 in.)
LV675.......................................................................................... 80.065 mm (3.1522 in.)
Max. Out-of-Round ........................................................................ 0.12 mm (0.0047 in.)
Max. Taper ..................................................................................... 0.05 mm (0.0020 in.)
Cylinder Head
Cylinder Head Fastener Torque (torque in 2 increments)...................... 16.9, 33.9 N·m (150, 300 in. lb.)
Max. Out-of-Flatness ............................................................................ 0.076 mm (0.003 in.)
Rocker Pivot Fastener Torque, if Screw................................................ 11.3 N·m (100 in. lb.)
Rocker Pivot Fastener Torque, if Nut .................................................... 15.8 N·m (140 in. lb.)
Electric Starter
Starter Mounting Fastener Torque ........................................................ 15.3 N·m (135 in. lb.)
Fan/Flywheel
Fan Fastener Torque ............................................................................ 13.6 N·m (120 in. lb.)
Flywheel Retaining Screw Torque ......................................................... 66.4 N·m (49 ft. lb.)
Governor
Governor Cross Shaft to Crankcase Running Clearance...................... 0.025/0.126 mm (0.0009/0.0049 in.)
Governor Cross Shaft O.D.
New................................................................................................ 7.949/8.000 mm (0.3129/0.3149 in.)
Max. Wear Limit ............................................................................. 7.936 mm (0.3124 in.)
Governor Gear Shaft O.D.
New................................................................................................ 5.990/6.000 mm (0.2358/0.2362 in.)
Max. Wear Limit ............................................................................. 5.977 mm (0.2353 in.)
Governor Gear Shaft-to-Governor Gear Running Clearance ................ 0.090/0.160 mm (0.0035/0.0063 in.)