Kohler CH1000 Automobile Parts User Manual


 
8
Check Oil Level
The importance of checking and maintaining the
proper oil level in the crankcase cannot be
overemphasized. Check oil BEFORE EACH USE as
follows:
1. Make sure the engine is stopped, level, and is cool
so the oil has had time to drain into the sump.
2. To keep dirt, debris, etc., out of the engine, clean
the area around the dipstick before removing it.
3. Remove the dipstick; wipe oil off. Reinsert the
dipstick into the tube and press all the way
down.
WARNING: Hot Parts!
Engine components can get extremely hot from operation. To
prevent severe burns, do not touch these areas while the engine
is running, or immediately after it is turned off. Never operate
the engine with heat shields or guards removed.
Engine Speed
NOTE: Do not tamper with the governor setting to
increase the maximum engine speed.
Overspeed is hazardous and will void the
engine warranty. The maximum allowable
high idle speed for these engines is 3900 RPM,
no load.
Maintenance Instructions
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the
customers expense, may be performed by any non-road engine repair establishment or individual. Warranty
repairs must be performed by an authorized Kohler service outlet.
WARNING: Accidental Starts!
Disabling engine. Accidental starting can cause severe injury or death. Before working on the engine or equipment, disable
the engine as follows: 1) Disconnect the spark plug lead(s). 2) Disconnect negative (-) battery cable from battery.
Maintenance Schedule
These required maintenance procedures should be performed at the frequency stated in the table. They should
also be included as part of any seasonal tune-up.
1
Perform these maintenance procedures more frequently under extremely dusty, dirty conditions.
2
Have a Kohler Engine Service Dealer perform this service.
Frequency
Maintenance
Daily or Before
Starting Engine
Fill fuel tank.
Check oil level.
Check air cleaner for dirty
1
, loose, or damaged parts.
• Check air intake and cooling areas, clean as necessary.
Seasonally or
Every 150 Hours
Replace air cleaner element
1
(flat air cleaner).
• Check heavy-duty air cleaner element.
Replace fuel filter.
Change oil. Oil filter is recommended. (More frequently under severe conditions.)
Remove cooling shrouds and clean cooling areas
1
.
Check oil cooler fins, clean as necessary.
Check spark plug condition and gap.
Change oil filter.
• Replace heavy-duty air cleaner element.
• Have solenoid shift starter disassembled and cleaned.
Have crankshaft splines lubricated
2
.
• Replace heavy-duty inner air cleaner element.
Replace spark plugs.
Every 200 Hours
Seasonally or
Every 300 Hours
Yearly or
Every 500 Hours
Every 600 Hours
Weekly
• Check filter minder or heavy-duty air cleaner element.
Every 25 Hours
• Service precleaner
1
(flat air cleaner).