Kenwood DNX7310BT GPS Receiver User Manual


  Open as PDF
of 58
 
1414 15
Return to the Top page
Basic Operations
Return to the Top page
Basic Operations
SD card
Press the <0> button for 1
second to open the front panel.
0
The panel fully opens.
Hold the SD card as the diagram
below and insert it into the slot
until it clicks.
Notchedsection
Labeledside
The unit loads the card and playback
starts.
● To remove:
Push the SD card until it clicks and then
remove your finger from the card. The
card pops up so that you can pull it out
with your fingers.
External device
Insert the plug into the AV-IN jack.
Detaching The Front
Panel
Youcandetachthefrontpaneltoprevent
theft.
Press the <0> button for 1 second
to open the front panel.
0
NOTE
•Youcansetthefrontpaneltoopenautomatically
whentheignitionisturnedoff.See Monitor
angle control (P.75).
Detach the panel as the diagrams
below.
2
3
1
4
NOTE
•Theattachingplateclosesautomaticallyinabout
10secondsafterthefrontpanelisreleased.
Removethepanelbeforethishappens.
1
2
1
1
2
Detach the panel as the diagrams
below.
1
2
● After detaching:
Putthepanelintheprotectivebag
suppliedwiththeunit.
NOTE
•Topreventdeterioration,donottouchthe
terminalsoftheunitandfaceplatewithyour
fingers.
•Iftheterminalsontheunitorfaceplategetdirty,
wipethemwithacleansoftdrycloth.
Attaching the front panel
Hold the panel securely so as not
to drop it accidentally, and fit it
onto the attaching plate until it is
firmly locked.
1
1
2
1
2
1
1
 previous next