Kenwood DNX7310BT GPS Receiver User Manual


  Open as PDF
of 58
 
7272 73
Return to the Top page
Setting Up
Return to the Top page
Setting Up
Travel Prayer for Safe Drive Setting
(DNX7310BTM/ DNX5310BTM only)
Whenthisfunctionisset,theprayerfor
drivingsafetyisdisplayedwhentheunitis
turnedon,thenQuranisplayed.
1
Touch [SET] of [Travel Prayer for Safe
Drive] in the User Interface screen.
Travel Prayer for Safe Drive Setting screen
appears.
2
Set each item as follows.
Travel Prayer for Safe Drive
TurnstheSafedriveprayfunctiononoroff.
Sound Volume
SetsthesoundvolumeofQuran.
Touch panel adjustment
1
Touch [Touch] in the System Menu
screen.
Touch Panel Adjustment screen appears.
2
Follow the instruction on the screen
and touch the center of each .
NOTE
•Tocancelthetouchpaneladjustment,touch
[Cancel].
•Toresettotheinitialstatus,touch[Reset].
Security setup
Aredindicatorwillblinkontheunitafterthe
ACCissettoOFF,warningpotentialthieves.
Ifturnedto“ON”(default),thesecurity
indicatoronthefrontpanelflasheswhenthe
vehicleignitionisoff.
1
Touch [Security] in the System Menu
screen.
Security screen appears.
2
Touch [ON] of [SI].
NOTE
•If“SI”isturnedon,theSIindicatoronthesub
panelflasheswhenthevehicleignitionisoffand
thepanelisdetached.Defaultis“ON”.
3
Touch [SET] of [Security Code Set].
NOTE
•Ifyouhavealreadycompletedthecode
registration,[CLR]isdisplayed.
4
Enter a security code with four-digit
number and touch [Enter].
5
Enter the same code again and touch
[Enter].
Security code is registered.
NOTE
•Ifyouenteradifferentsecuritycode,thescreen
returnstostep4(forthefirstcodeentry).
•Ifyouhavepressed<Reset>buttonorifyou
havedisconnectedtheReceiverfrombattery,
enterthecorrectsecuritycodeasthatyouhave
enteredinstep4andtouch[Enter].Youcanuse
yourReceiver.
EXT SW setup
Setuptheexternalswitchpowermode.
1
Touch [EXT SW] in the System Menu
screen.
EXT SW screen appears.
2
Set each item as follows.
SW Name
Setsthenameoftheexternaldevice.
Output Pattern
Setsthepowersignaloutputmodeamong
“Pulse”/“Level”.Defaultis“Pulse”.
Youcansettoturnoutputon/offeachtime
thebuttonontheEXTSWscreenistouched.
SeeExternal Device Control (P.81).
Pulse Set
Setsthepulsesignaloutputtime.
Outputs500mswhen“1”isset.
Increasesby200mswitheachstep.Upto100
stepscanbeset.
NOTE
•Youcanentercharactersonlyafteryouhave
appliedtheparkingbrake.
•“Pulse”:Generatesasinglepowersignalpulse.
•“Level”:Continuesoutputofhighpowersignal.
 previous next