Filter
Top Products
DDX series DDX896/ DDX8046BT
English
117
Next page 3
Help? Error
When the unit fails to operate correctly,
the cause of the failure appears on the
display.
"Protect" :
Protective circuit has been activated because
a speaker cord has shorted or it has come in
contact with the car chassis.
➡ Wire or insulate the speaker cord as
appropriate and then push the Reset
button.
"Hot Error" :
When the internal temperature of this unit
rises to 60°C or more, the protection circuit is
activated and you may not be able to operate
the unit. At such times this message will
appear.
➡ Use the unit again after reducing the
temperature inside the vehicle.
"Mecha Error" :
The disc player is malfunctioning.
➡ Eject the disc and try inserting it again.
Contact the Kenwood dealer if this indicator
continues blinking or the disc cannot be
ejected.
"Disc Error" :
An unplayable disc is inserted.
"Read Error" :
Disc is quite dirty.
➡ Clean the disc, referring tot he section on
<Handling discs> (page 4).
Disc is upside down.
➡ Load the disc with the labeled side up.
"Region code Error" :
The disc you wanted to play has a region code
that cannot be played with this unit.
"Parental level Error" :
The disc you wanted to play has a higher level
than the parental level you set.
"Error 07–67" :
The unit is not operating correctly due to
some reason or other.
➡ Push the unit's Reset button. If the "Error
07−67" message does not disappear, see
your nearest Kenwood dealer.
"No Device" (USB device):
The USB device is selected as a source
although no USB device is connected.
➡ Change the source to any source other
than USB/iPod. Connect an USB device, and
change the source to USB again.
"Disconnected" (iPod, Bluetooth audio
player):
The iPod/Bluetooth audio player is selected
as a source although no iPod/Bluetooth audio
player is connected.
➡ Change the source to any source other than
iPod/Bluetooth. Connect an iPod/Bluetooth
audio player, and change the source to
iPod/Bluetooth again.
"No Music" :
The connected USB device contains no
playable audio file.
Media was played that doesn’t have data
recorded that the unit can play.
"USB Device Error!!" :
The connected USB device is rated a current
capacity higher than the allowable limit.
➡ Check the USB device.
Some trouble may have occurred to the
connected USB device.
➡ Change the source to any source other than
USB. Remove the USB device.
"Authorization Error" :
Connection to the iPod has failed.
➡ Remove the iPod and then reconnect it.
The unit does not support the iPod.
➡ Refer to <iPod/iPhone that can be
connected to this unit> (page 7).