Filter
Top Products
22 ñ English
ÑTrim plate
1) Attach accessory 6 to the unit.
6
ÑGPS antenna (DNN9150BT/ DNN9150BTM)
GPS antenna is installed inside of the car. It should
be installed as horizontally as possible to allow easy
reception of the GPS satellite signals.
To mount the GPS antenna inside your vehicle:
1) Clean your dashboard or other surface.
2) Remove the separator of the metal plate
(accessory 8).
3) Press the metal plate (accessory 8) down firmly
on your dashboard or other mounting surface.
You can bend the metal plate (accessory 8) to
conform to a curved surface, if necessary.
4) Remove the separator of the GPS antenna
(accessory 7), and stick the antenna to the
metal plate (accessory 8).
8
7
✎ NOTE
• Depending on the type of car, reception of the GPS
satellite signals might not be possible with an inside
installation.
• Please install this GPS antenna in an area away from
any antennas that are used with CB radios or satellite
televisions.
• The GPS antenna should be installed at a position
that is spaced at least 12 inch (30 cm) from cellular
phone or other transmitting antennas. Signals from
the GPS satellite may be interfered with by these
types of communication.
• Painting the GPS antenna with (metallic) paint may
cause a drop in performance.
ÑMicrophone unit
1) Check the installation position of the
microphone (accessory 9).
2) Clean the installation surface.
3) Install the microphone.
4) Wire the microphone cable up to the unit with it
secured at several positions using tape or other
desired method.
9
Fix a cable with a commercial item of tape.
Remove the separator of the microphone, and stick
the microphone to the place shown above.
Adjust the direction of the microphone to the
driver.
✎ NOTE
• Install the microphone as far as possible from the
cell-phone.