Kenwood DDX896 GPS Receiver User Manual


 
DDX series DDX896/ DDX8046BT
English
117
Next page 3
Help? Error
When the unit fails to operate correctly,
the cause of the failure appears on the
display.
"Protect" :
Protective circuit has been activated because
a speaker cord has shorted or it has come in
contact with the car chassis.
Wire or insulate the speaker cord as
appropriate and then push the Reset
button.
"Hot Error" :
When the internal temperature of this unit
rises to 60°C or more, the protection circuit is
activated and you may not be able to operate
the unit. At such times this message will
appear.
Use the unit again after reducing the
temperature inside the vehicle.
"Mecha Error" :
The disc player is malfunctioning.
Eject the disc and try inserting it again.
Contact the Kenwood dealer if this indicator
continues blinking or the disc cannot be
ejected.
"Disc Error" :
An unplayable disc is inserted.
"Read Error" :
Disc is quite dirty.
Clean the disc, referring tot he section on
<Handling discs> (page 4).
Disc is upside down.
Load the disc with the labeled side up.
"Region code Error" :
The disc you wanted to play has a region code
that cannot be played with this unit.
"Parental level Error" :
The disc you wanted to play has a higher level
than the parental level you set.
"Error 07–67" :
The unit is not operating correctly due to
some reason or other.
Push the unit's Reset button. If the "Error
07−67" message does not disappear, see
your nearest Kenwood dealer.
"No Device" (USB device):
The USB device is selected as a source
although no USB device is connected.
Change the source to any source other
than USB/iPod. Connect an USB device, and
change the source to USB again.
"Disconnected" (iPod, Bluetooth audio
player):
The iPod/Bluetooth audio player is selected
as a source although no iPod/Bluetooth audio
player is connected.
Change the source to any source other than
iPod/Bluetooth. Connect an iPod/Bluetooth
audio player, and change the source to
iPod/Bluetooth again.
"No Music" :
The connected USB device contains no
playable audio file.
Media was played that doesn’t have data
recorded that the unit can play.
"USB Device Error!!" :
The connected USB device is rated a current
capacity higher than the allowable limit.
Check the USB device.
Some trouble may have occurred to the
connected USB device.
Change the source to any source other than
USB. Remove the USB device.
"Authorization Error" :
Connection to the iPod has failed.
Remove the iPod and then reconnect it.
The unit does not support the iPod.
Refer to <iPod/iPhone that can be
connected to this unit> (page 7).