Filter
Top Products
Assembly
TM
• Press the tab under the back of the
seat and lift to remove the seat.
• Make sure the motor harness wires are positioned in
the channel to prevent them from being pinched
between the cowling and vehicle body.
• Fit the rectangular opening in the cowling over the
shifter handle.
• Align the front, side and rear tabs on the cowling with
the slots in the vehicle body but do not snap the tabs
into the slots.
T
M
Cowling
Shifter
Handle
Side
Tab
Side
Tab
Rear Tab
• Press firmly on the front of the cowling to snap the four
front tabs into the slots in the vehicle body. Make sure
the side and rear tabs stay aligned with the slots.
Note: Pull up on the front of the vehicle body while
pressing down on the cowling to make sure the front
tabs snap into the slots.
11
6
7
Motor
Harness
PRESS COWLING HERE
To Snap Front Tabs
PULL VEHICLE
BODY UP HERE
To Snap Front Tabs
• Press firmly on the back of the cowling to snap the rear
tab into the slot in the vehicle body.
T
M
PRESS HERE
To Snap Side Tabs
PRESS HERE
To Snap Rear Tab
• Press firmly on each side of the cowling to snap the
four side tabs into the slots in the vehicle body. Make
sure the rear tab stays aligned with the slot.
Note: You may need to flex the shifter to the side to fit
the cowling over the high speed lock-out screw.
9
8