Filter
Top Products
14
INSTALLATION AND CONNECTION
11. Insert the cable in the seal and push
it into the cable clips in the casing
(see illustration on the right).
12. Use the plugs attached to seal the
cable attachment points that are now
not required (see illustration on the
right).
Do not cut away any plugs that are
not required, you will need them
if you ever wish to remove the
turntable system.
13. Now place the cover on the casing
lower half and screw the two halves
together using the four screws pre-
inserted in the cover (tightening
torque: M
A
= 1-1.5 Nm).