JVC GR-SX22 Automobile Electronics User Manual


 
30 EN
1
Load a tape ( pg. 13).
2
Set the Power Switch to “ ”.
To start playback, press
4
/6.
•To stop playback, press 5.
•Press
2
to rewind, or
3
to fast-forward the tape
during Stop mode.
NOTES:
The camcorder shuts off automatically after about
5 minutes in Stop mode. To turn on again, set the Power
Switch to OFF, then to .
When the Power Switch is set to and the LCD
monitor is opened at an angle of 60 degrees or more, the
LCD monitor switches on and the viewfinder switches
off automatically to save power (models equipped with
LCD monitor only).
The playback picture can be viewed in the viewfinder
(with the LCD monitor* shut), on the LCD monitor* or
on a connected TV (
pg. 32, 33).
*Models equipped with LCD monitor only.
You can also view the playback picture on the LCD
monitor with it flipped over and retracted (models
equipped with LCD monitor only).
If a blank portion on the tape is played back, the screen
may become black. This is not a malfunction.
PLAYBACK
Basic Playback
Rewind (
2
) Button
Fast-Forward (
3
) Button
Play/Pause (
4
/6) Button
Stop (5) Button
Power Zoom
Lever (VOL.*)
BRIGHT* Wheel
Set to “ ”.
Speaker*
LCD Monitor Brightness Adjustment (models equipped with LCD monitor only):
Rotate BRIGHT towards + to brighten, or towards to darken.
The Bright Level Indicator is displayed under the Date/Time Display when you play back images recorded in
Wide Mode (
pg. 23).
Speaker Volume Control (models equipped with LCD monitor only): Slide the
Power Zoom Lever (VOL.) towards + to turn up the volume, or towards to turn down the volume.
The Speaker Volume Indicator is displayed under the Date/Time Display when you play back images
recorded in Wide Mode (
pg. 23).
Still Playback: Pauses during playback.
1)Press
4
/6 during playback.
2)To resume normal playback, press
4
/6 again.
Noise bars will appear and the picture will become monochrome during Still Playback.
Shuttle Search: Allows high-speed search in either direction.
1)Press
3
for forward or
2
for reverse search during playback.
2)To resume normal playback, press
4
/6.
During playback, press and hold
2
or
3
. The search continues as long as you hold the button. Once you
release it, normal playback resumes.
Noise bars appear and pictures may become monochrome or darken during Shuttle Search. This is normal.
*Models equipped with LCD monitor only.