Filter
Top Products
EN35
I T E M S N O T E S
❍ Perform charging where the temperature is between 10°C and 35°C. 20°C
to 25°C is the ideal temperature range for charging. If the environment is
too cold, charging may be incomplete.
❍ Charging times are for a fully discharged battery pack.
❍ Charging time varies according to the ambient temperature and the status of
the battery pack.
❍ To avoid interference with reception, do not use the AC Adapter near a
radio.
❍ Since the AC Adapter processes electricity internally, it becomes warm
during use. Be sure to use it only in well-ventilated areas.
❍ The following operation stops charging or discharging:
•Set the Power Switch to “ ”, “ ” or “ ”.
•Disconnect the AC Adapter from the camcorder.
•Unplug the AC Adapter’s power cord from the AC outlet.
•Detach the battery from the camcorder.
❍ The date/time cannot be stored in memory if the built-in clock battery runs
out. Consult an authorised JVC dealer for replacement, or set the date/time
as necessary before you start shooting.
❍ When the Power Switch is set to “ ” or “ ” and the LCD monitor is
opened at an angle of 60 degrees or more, the LCD monitor switches on
and the viewfinder switches off automatically to save power (models
equipped with LCD monitor only).
❍ The cassette holder cannot be opened unless a power supply is attached.
❍ There may be a delay after you slide EJECT until the cassette holder opens.
Do not use force.
❍ The time required to calculate the remaining tape length, and the accuracy
of the calculation, may vary according to the type of tape used.
❍ The tape remaining time indicator is correct only if the correct tape length
has been selected (੬ pg. 12).
❍ “TAPE END” appears when the tape reaches its end, and the power goes off
automatically if left in this condition for 5 minutes.
“TAPE END” also appears when a cassette whose tape is already at its end
is loaded.
❍ If the Recording Start/Stop button is pressed after the Record-Standby mode
has continued for over 5 minutes, recording may not start immediately.
❍ While shooting, sound is not heard from the speaker (models equipped
with LCD monitor only).
❍ The “TBC” indicator turns green (grey with a camcorder equipped with a
black/white viewfinder) while TBC is working.
❍ TBC does not work during still playback and shuttle search.
❍ The “TBC” indicator turns white while TBC is not operative.
❍ It may take a few seconds before TBC actually starts working.
❍ The picture may be distorted if the TBC mode is activated or deactivated at
the edit-in/-out points or when normal playback resumes after still playback
or shuttle search.
❍ If the playback picture is distorted when TBC is set to on, turn off TBC.
DETAILS
➪ Date/Time
Settings
(
੬ pg. 9)
➪ Power
(
੬ pg. 6)
➪ TBC
(Time Base
Corrector)
(
੬ pg. 31)
➪ Recording
(
੬ pg. 14, 15)