Filter
Top Products
Assembly
• Position the vehicle body upright.
• Fit the peg on the left side of the seat into the hole in
the left side of the vehicle body .
• Push firmly near the peg on the right side of the seat
to snap it into the hole in the right side of the vehicle
body .
11
2
11
1
• Fit the key assembly into the large hole below
the handlebar.
• Bend the end of the microphone cord so that the tip
forms a "T".
• Fit the end of the microphone cord into the small hole
below the handlebar. Pull up gently on the microphone
cord to make sure it is secure.
• Fit the tab on the back of the microphone into the notch
on the side of the vehicle body.
One-time assembly is now complete.
Microphone
Microphone
Cord
Notch
Hole
Hole
Left
Peg
Right
Peg
Key
Assembly
11
1
11
2
10
12
13
74240b-0920 pgs. 6-12 11/30/01 12:20 PM Page 5