Filter
Top Products
8
System Layout
IMPORTANT!!!
The module MUST be programmed before it will operate.
Refer to the programming instructions on pages 9-11.
View from wire end
Basic Harness
1 PARKING LIGHT OUTPUT (WHITE)
2 LOCK MOTOR OUTPUT (BLUE)
3 UNUSED
4 BATTERY (+12V) (RED)
5 GROUND (BLACK)
6 STARTER KEY (+) (VIOLET/RED)
7 IGNITION 1 INPUT/OUTPUT (+) (PINK)
8 STARTER MOTOR (+) (VIOLET)
9 DISARM INPUT (+)
10 UNUSED
11 ARMED OUTPUT (WHITE/BLUE)
12 UNLOCK SENSE (LIGHT GREEN)
13 TRUNK MOTOR OUTPUT (TAN)
14 UNLOCK MOTOR OUTPUT (GREEN)
15 UNUSED
16 HORN SIREN (-) 1 AMP (BLACK)
17 DISARM OVERRIDE BUTTON INPUT (GROUND) (PLUG-IN)
18 DISARM OVERRRIDE BUTTON (GROUND)
19 HOOD PIN INPUT (GRAY)
20 DOOR TRIGGER INPUT (GREEN/VIOLET)
21 TRUNK (-) 500mA (BROWN/BLACK)
22 LED 2 (RED) (PLUG-IN)
23 LED 1 (BLACK) (PLUG-IN)
24 ILLUMINATED ENTRY (BLUE/GREEN)
314151617181 910212223242
123456789011121
Not Used.
Not Used.
9
Programming Selectable Options
Programming Selectable Options using a generic Code Alarm
remote.
Programming the Remote Transmitter
1. Open the driver’s door.
2. Turn vehicle ignition on.
3. Press and hold emergency override button. After 15 seconds,
the siren or horn will sound three (3) times. This indicates that the
unit has entered the transmitter programming mode.
4. Release the button.
5. Press the Arm button on the remote transmitter to be programmed.
The siren or horn will sound once, indicating that the system has
“learned” that remote transmitter.
Programming Options
1. Repeat steps 1-4 of Programming the RemoteTransmitter
1. Press and release the emergency override button.
The horn or siren will sound four (4) times. This indicates that the
unit has entered the Keyless Options Programming mode.
2. Press the FIND/PANIC button to advance to the next feature.
The siren or horn will sound a number of times to indicate the
number of the option.
3. Press the ARM button to turn the option on or off. The vehicle
status indicator on the dashboard indicates whether an option
is on or off.
• If the selected option is ON, the indicator will light.
• If the selected option is OFF, the indicator will turn off.
• The status indicator will turn on or off when an option is changed.
5. When changes are complete, press and release the emergency
override button to continue to the next option bank. (Siren or horn
will sound five (5) times.)
6. To reset all options back to factory defaults, press the
DISARM button.
Note: Option Bank Installer options will never reset.
7. Turn ignition off to exit programming.
See Programmable Options Chart on Page 11.